4WD Switch Relocation Kit for Bombardier/Can-AmBuy Now
4WD Switch Relocation Kit, 11-0056
posted Jul 16, 2012
Tags: Instructions All Article Tags
IMPORTANT – FULLY READ INSTRUCTIONS BEFORE INSTALLING. THIS KIT IS INTENDED FOR INSTALLATION BY A TRAINED TECHNICIAN WHO IS FULLY FAMILIAR WITH THE ATV IN A PROPERLY EQUIPPED SHOP.
THESE INSTRUCTIONS ARE FOR USE WITH TWIST THROTTLE KITS. THESE KITS ARE DESIGNED TO REPLACE THE ORIGINAL THUMB THROTTLE WITH A TWIST THROTTLE. THESE INSTRUCTIONS SHOW HOW TO RELOCATE THE 4WD SELECTOR SWITCH(S) FROM THE ORIGINAL EQUIPMENT THUMB THROTTLE. REFER TO THE SEPARATE THROTTLE AND THROTTLE KIT INSTRUCTIONS FOR SPECIFIC INSTRUCTIONS ON INSTALLING THE TWIST THROTTLE AND CABLE.
Qty 2 (5 mm x 0.8 x 18L countersunk screw)
Qty 2 (6 mm x 1.0 x 30L hex bolt w/8mm HD)
Qty 2 (5 mm x 0.8 x 16L Philips HD screw)
1. Remove the upper thumb throttle/4x4 switch housing assembly from the bottom thumb throttle housing. Retain the original fasteners for reuse. Assemble the two plates together using the provided 5mm countersunk screws (Fig.1). Mount the upper thumb throttle 4x4 switch onto the upper plate using the two 5 mm Philips head screws (Fig.2).
2. Mount the switch bracket to the brake mastercylinder by removing the original mount bolts. Using the two longer 6mm bolts provided (one in place from step one), mount the switch bracket through the original mastercylinder bracket to the master cylinder (Fig.3). Torque the 6mm bolts to the factory specification once the mastercylinder has been correctly positioned.