Featured Products
-
08-0368
Rear Wheel Alignment Tool for HD
Buy Now
Tech
Rear Wheel Alignment Tool for HD, 08-0368
posted Jan 30, 2013Tags: Instructions All Article Tags
.jpg)
For Dyna and Sportster Models
Place end of tool “A” into small hole in swing arm located approximately 6” in front of rear axle. Place thumb screw pointer “B” in center of rear axle. Do this on both sides of the bike, and with the rear axle loosened, use the rear axle adjusters until “A” and “B” are the same distance apart on both sides. When finished, re-tighten the rear axle, and check belt tension using Motion Pro Part # 08-0350.
.jpg)
For Softail Models
Place end of tool “C” into center of swing arm pivot shaft bolt. Place thumb screw pointer “B” in center of rear axle. Do this on both sides of the bike and with the rear axle loosened, use the rear axle adjusters until “C” and “B” are the same distance apart on both sides. When finished, re- tighten the rear axle, and check belt tension using Motion Pro part # 08-0350.
* Note: Some exhaust systems may cause clearance issues when using this tool
.jpg)
