Support » Tools » Problems
All Problems for Tools
on the carb sync tool 08-0411. i had 2 of the chambers with the blue fluid get sucked out and the other 2 are low. my question is how do you add more of the blue die in to the tool???
MP User three weeks ago
MP User three weeks ago
1
Click the star to add your vote.
Solved
1
Click the star to add your vote.
2 Stroke Timing Adapter 3801-0029 MP# 08-0249
Robert U 17 months ago
Robert U 17 months ago
Solved
1
Click the star to add your vote.
Need can of cable lube but site doesn't show my pending order
MP User 18 months ago
MP User 18 months ago
Solved
1
Click the star to add your vote.
Trying to calibrate the SynchPro that I just purchased.
J. Michael M three years ago
J. Michael M three years ago
Solved
1
Click the star to add your vote.
Leak down tester will not seal at spark plug hole. O ring is on the hose but air still escapes. 2007 Honda CRF 250 R. Thanks!
Steve D three years ago
Steve D three years ago
Solved
1
Click the star to add your vote.
Brand new Sync Tool not working (fluid draw out)
Robert P three years ago
Robert P three years ago
Solved
2
Click the star to add your vote.
Motion Pro Professional Tire Pressure Gauge 2.5" 0-60
Elias R three years ago
Elias R three years ago
Solved
1
Click the star to add your vote.
Solved
1
Click the star to add your vote.
My shop recently bought some Motion Pro Wheel Weights. I think the adhesive is defective, becuase we can't get them to stick to our wheels.
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
I just recently bought one of your liquid filled tire gauges, and it seems to be off by 2-3psi.
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
I think I have a problem with my Two Stroke Leak Down Tester, it won't hold pressure. If I put my thumb over the end of the hose, and try to pump it up, I can't get any pressure.
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
My compression tester won't hold the pressure after I stop cranking the engine. Is the gauge defective?
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
I was calibrating my Syncpro, and it calibrated just fine, but then when I went to synchronize my carbs, the fluid got all pulled out of the tubes!
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
I was using my Syncpro and now the fluid is all stuck up in the tubes. The instructions say to shake it down like a thermometer, but that doesn't work at all. Can you help me with this?
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
I was using my 08-0058 Chain Tool to flare a rivet master link, and the large anvil cracked. What can I do?
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
I was using my chain breaker, and the hex on the body bolt broke while I was tightening it. When I removed it from the chain, the chain was untouched, and the pin was also broken inside the tool. What did I do wrong?
Common Question three years ago
Common Question three years ago
Solved
1
Click the star to add your vote.
Ask a Question
Share an Idea
Report a Problem