Support » Cables » Question
Idle Screw Failure
Hi, i recently purchased a T.O.R.S. eliminator kit for a 96' Yamaha Banshee on eBay. It didn't include the idle screws or drill and tap, so i purchased the screws from the same guy that i bought the eliminator kit from. When i put the idle screws in, they failed to adjust the height of the slide. So, 1. how long should the idle screws be, and 2. do you have some kind of instructions or diagram to show how to install? I tried to contact the guy that sold me the parts, but he said he couldn't help me and to contact Motion Pro myself. Please get back to me, thankyou! Tom.
1
I have this question too
The best answers
Chris V
replied 15 months ago
Hello,
I am sorry, but we are not able to assist you with anything that is not our product. The Motion Pro Idle Screw Kit works for stock Banshee carburetors. Our Idle Kit, part number 08-0045, comes with screws, a tap and a drill and thorough instructions on how to perform the installation.
I am sorry, but we are not able to assist you with anything that is not our product. The Motion Pro Idle Screw Kit works for stock Banshee carburetors. Our Idle Kit, part number 08-0045, comes with screws, a tap and a drill and thorough instructions on how to perform the installation.
This question has been answered.
I bought the motion pro kit from a seller on eBay, and did not know the idle screws came separate.So I ordered them from the same seller to insure they were the correct ones for the kit. The part number for the idle screws i bought is part #08-0045. They seem to bottom out before they are able to reach to slide to make the adjustment. Do you have any kind of diagram or instructions? I was told by the seller to contact motion pro directly because he "didn't want to open the package" to fax me the instruction kit. Thanks for your help!
Comment on Tom B's reply
It IS your product. The seller didn't include any instructions. I'm wondering if you can get them for me via link or e-mail?