Support » Controls » Question
Motion Pro Starter/Kill Switch Installation - GSX-R 1000
I bought the kill switch for the Revolver Throttle for a 2006 GSX-R 1000. I cannot find the factory electrical connectors to splice the wires for use in the factory wiring harness, and am trying to follow the suggestions in the YouTube video produced by Motion Pro. The installer had them available for Suzuki motorcycles, which are the default ones on the MoPro switch (would've been nice to have extras) Where can these be found?
1
I have this question too
The best answers
Morgan S
replied 15 months ago
Hello-
We receive the start/stop switch 11-0057 complete with connectors from the supplier.
The supplier does not add extra connectors and neither do we.
However, extra conntectors can be purchased from K&L Supply Co.
Each item is a pack of ten a unit of measure.
K&L part numbers below.
34-8959 (B-1 male connector)
34-8960 (B-2 female conntector)
34-8961 (B-3 male terminal cover for B-1)
34-8962 (B-4 female terminal cover for B-2)
K&L is a distributor so the customer will need to purchase through a K&L dealer in their area.
K&L’s website is http://www.klsupply.com/
Please contact us if you have any further questions or concerns. Thank you.
We receive the start/stop switch 11-0057 complete with connectors from the supplier.
The supplier does not add extra connectors and neither do we.
However, extra conntectors can be purchased from K&L Supply Co.
Each item is a pack of ten a unit of measure.
K&L part numbers below.
34-8959 (B-1 male connector)
34-8960 (B-2 female conntector)
34-8961 (B-3 male terminal cover for B-1)
34-8962 (B-4 female terminal cover for B-2)
K&L is a distributor so the customer will need to purchase through a K&L dealer in their area.
K&L’s website is http://www.klsupply.com/
Please contact us if you have any further questions or concerns. Thank you.